Do you have a plan to purchase a satellite dish? Here is an essential guide on the proper installation of your satellite dish, and this has been made through research of the different brands available. Remember if this is beyond your skills the Luxury lifestyle blog offers tips on how to find a satellite installation Pwllheli company.
Know Important Satellite Dish Equipment
A satellite dish is not a soft toy. It is a technologically groundbreaking piece of tool or machinery, and therefore knowing the parts will assist you in installing it without any issues. The different elements that you have to know take account of:
- LNB
- The reflector or dish
- Mounting hardware like bolts and screws
Understand the Type of Satellite Dish you are installing
A second essential step is to know whether you are installing an elliptical multi satellite television dish or the typical satellite dish. The elliptical dish has a dimension of 18 by 24 inches while the conventional dish measures 18 inches.
Set the Satellite Dish
Here is how to measure the angle. You have to write them down for you to make the settings accordingly.
Azimuth: ____________
Elevation: ____________
Tilt: ____________ (Skew)
Mounting the Dish
Don’t simply go ahead and then mount the dish, first and foremost you need to check the manual. The manual has step by step guide of assembling the satellite dish.
Keep in mind that the LNB arm requires a special mention here. It comes with a clamp that will glide down over a mast to set it in the right position. If this is obtained, you can mount the mast and the foot assembly as specified in the guide. To keep mast vertically and horizontally straight, you have to make use of a plumb bob.
Dish Alignment
Utilize a compass and a pencil for lining up your satellite dish in a way so that it can place the satellite signal. Then, slowly mount the satellite dish assembled by gliding down the clamp over the mast arm. Tighten the bolts to hold it firm and keep in mind not to tighten it extremely hard that it becomes hard to turn afterward. Use the tilt or skew coordinates to set the skew of the satellite dish to the particular place. When done, set the elevation utilizing the angle calculator.
Find the Signal
Run the cables from the receiver to your satellite dish. If it is in place, switch on the satellite receiver. Keep in mind to place the receiver in the satellite dish pointing or signal pointing mode when you enter the setup menu. Read the manual. The next thing to do is to stand behind the dish to moved three degrees to the right. Check the signal. If there is no signal, move the dish by 3 more degrees towards your right side and once more check for a signal. Keep on this process until you get a strong signal that must be 75 and 100 on the signal meter.
If you can pick up any signals, although you tried all the steps required, it is vital to call a professional installation company
